收藏本站
TEA1750_2
?NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 02  15 December 2008
6 of 29
NXP Semiconductors
TEA1750
GreenChip III SMPS control IC
When the PFC is started, there is initially no supply take-over from the auxiliary winding.
To make a small V
CC
 capacitor possible, the V
CC
 voltage is regulated to the V
startup
 level,
as long as the yback converter has not yet started. Regulation is done by hysteretic
control with a limited (high level) charge current. The hysteresis is typically 300 mV.
If during start-up the LATCH pin does not reach the V
en(LATCH)
 level before V
CC
 reaches
V
th(UVLO)
, the LATCH pin output is de-activated and the charge current is switched on
again.
As soon as the yback converter is started, the voltage on the FBCTRL pin is monitored. If
the output voltage of the yback converter does not reach its intended regulation level in a
predened time, the voltage on the FBCTRL pin reaches the V
to(FBCTRL)
level and an error
is assumed. The TEA1750 then initiates a safe restart.
When one of the protection functions is activated, both converters stop switching and the
V
CC
 voltage drops to V
th(UVLO)
. A latched protection recharges the V
CC
 capacitor via the
HV pin, but does not restart the converters. For a safe-restart protection, the capacitor is
recharged via the HV pin and the device restarts (see
Figure
1)
In the event of an overvoltage protection of the PFC circuit
(V
I
on pin VOSENSE > V
ovp(VOSENSE)
), only the PFC controller stops switching until the
VOSENSE pin voltage drops below V
ovp(VOSENSE)
 again. Also, if a mains undervoltage is
detected (V
I
on pin VINSENSE < V
stop(VINSENSE)
), only the PFC controller stops switching
until V
I
on pin VINSENSE > V
start(VINSENSE)
 again.
When the voltage on pin V
CC
drops below the undervoltage lock-out level, both controllers
stop switching and re-enter the safe restart mode. In the safe restart mode the driver
outputs are disabled and the V
CC
 pin voltage is recharged via the HV pin.
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
TEA1751T/N1,518 IC CTRLR GREENCHIP SMPS 16-SOIC
TEA1761T/N2,118 IC CTRLR GREENCHIP SYNC 8-SOIC
TEA1762T/N2/DG,118 IC CTLR SMPS SW SO14
TEA1791T/N1,118 IC CTRLR GREENCHIP SYNC 8-SOIC
TMP03FS-REEL IC SENSOR TEMP/SERIAL OC 8SOIC
TMP141AIDBVTG4 IC TEMP SENSOR DGTL OUT SOT23-6
TMP401AIDGKTG4 IC TEMP SENSOR DGTL OUT 8-MSOP
TPS2346PWRG4 IC HOT SWAP POWER MGR 24-TSSOP
相关代理商/技术参数
TEA1750T/N1/DG,518 功能描述:DC/DC 开关控制器 12V -80uA 125KHz RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TEA1750T-T 功能描述:DC/DC 开关控制器 GREENCHIPIII RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TEA1751AT/N1,518 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TEA1751AT/N1518 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述:
TEA1751LT 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:GreenChip III SMPS control IC
TEA1751LT/N1 制造商:NXP Semiconductors 功能描述:AC-DC PFC FLYBACK CNTRL 16SOIC 制造商:NXP Semiconductors 功能描述:AC-DC, PFC, FLYBACK, CNTRL, 16SOIC 制造商:NXP Semiconductors 功能描述:GreenChip III SMPS Control 16-Pin SO
TEA1751LT/N1,518 功能描述:DC/DC 开关控制器 GREENNCHIP SMPS CONTROL IC RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TEA1751LT/N1518 制造商:NXP Semiconductors 功能描述:IC SMPS SOIC-16